International Science Community Association Research Journal of Engineering Sciences 2278 - 9472 5 9 2016 09 26 An Experimental Study of Low Frequency Vibration Assisted EDM in AISI 1045 Steel 11 16 EN Idowu H.* Adebakin 1 Department of Civil Engineering, Yaba College of Technology, Yaba, Lagos, Nigeria Tajudeen O. Ipaye 2 Department of Civil Engineering, Lagos State Polytechnic, Ikorodu, Lagos, Nigeria Agrawal* Ritu 1 Chhattisgarh Swami Vivekananda Technical University, Bhilai, India Sharma Manisha 2 Department of Electronics and Telecommunications, Bhilai Institute of Technology, Durg, Chhattisgarh, India Kumar Sandeep 1 University Institute of Engineering and Technology, Rohtak, Haryana, India Kumar Sanjay 2 YMCA University of Science and Technology, Faridabad, Haryana, India Kumar* Sumit 3 University Institute of Engineering and Technology, Rohtak, Haryana, India Saini Tarun 4 University Institute of Engineering and Technology, Rohtak, Haryana, India . Sumit 5 University Institute of Engineering and Technology, Rohtak, Haryana, India > Research Article 2016 7 30 2016 09 26 This experimental study helps to analyze the performance characteristics of ultrasonic vibration assisted EDM process. The objective of the present work was to investigate the effect low frequency vibration given to workpiece which taken as an input factor with other parameters of WEDM on the cutting speed and surface roughness of machining process. This happened with the help of fixture and vibration actuator. By the help of this vibration unit vibration produced to the workpiece, this vibration removed the debris fast and our cutting speed increased. And with increasing speed the surface roughness minimized. The working ranges and levels of the WEDM process parameters are found from literature survey to investigate the effects of wire WEDM we use Taguchi Method. Copyright@ International Science Community Association